Pro Audio Files

Train Your Ears Become a Member

3 EQ Techniques That Can Get You In Trouble

Article Content

EQ is a pretty powerful tool. More powerful than almost every other tool in your mixing toolkit (second only to the volume fader).

And with great power comes great responsibility. Also, with great power comes great mistakes.

If you’re reading this, it shouldn’t be any surprise to you that there are plenty of ways people struggle with EQ. Sometimes the sound ends up worse than it started. Sometimes it takes far longer to get the sound than it otherwise should.

And so here are three different EQ techniques people use that can sometimes do more harm than good. I know, I’ve used them too.

1. High-Pass Everything by Default

This is a good one. “High-pass everything except kick and bass.” Every time. Cut out unnecessary junk. It’s just rumble and mud down there. Sound familiar?

Well, high-passing everything is probably a good idea if you’re mixing a monster track with 100+ tracks. If you’ve got that much stuff to jam together, most of the sounds will need to be pretty small.

But if your track needs a bit more life and realism, think before you high-pass. Even better, listen before you high-pass. Because they’re right — there’s some rumble and mud down there. But there’s also a lot of weight and warmth and vibe down there too.

By all means, don’t be shy about that high-pass filter. But realise it’s just a tool. And sometimes it’s not the best tool for the job. Sometimes you need some weight and warmth — even for tracks that aren’t labelled ‘Kick’ or ‘Bass’.

2. Cutting Your Sound to Shreds

Cutting is better than boosting, right? Well, sometimes.

ADVERTISEMENT

Do you use the ‘boost and sweep’ method to ‘find bad frequencies’?

Well, here’s the trap — when you’re looking for “bad frequencies,” you’ll find them. You’ll find heaps of them. Because when you boost a narrow range and sweep it all over the place, every frequency is going to sound pretty terrible. And then you’ll cut. And cut and cut and cut. How good is it that DAWs and digital mixers have four, five, eight, ten bands of EQ of every channel? Now you can cut all the bad frequencies!

If you know what I’m talking about, you’ll know that your sound very quickly starts to resemble a Worms game. And you can use a lot of different words to describe your sound, but ‘warm’, ‘thick’ and ‘juicy’ won’t be among them.

Don’t cut holes in your sound.

3. Forgetting to Try Switching Polarity

Here’s one for the recordists out there. Any time you bring out two or mics at the same time, phase and polarity start getting interesting. Before you reach for EQ, try flipping the polarity on one of the channels (it doesn’t matter which one). Sometimes it’ll get you close to the sound you want faster than any EQ. You can fight and fight and fight with EQ, when a simple polarity flip will do all the work for you.

It won’t always work, but when it does you’ll feel like you just cheated a bit. That’s how easy it is.

So don’t stop thinking, and don’t stop listening. Don’t take anything for granted. And don’t forget that the less EQ you use, the more integrity is retained in the sound.

EQ is a powerful tool. So I recommend trying to find ways to use it as little as possible.

Kim Lajoie

Kim Lajoie

Kim Lajoie is a Melbourne music producer specializing in composition, project management and digital audio technology. More at kimlajoie.com.

FREE Masterclass: Low-End Mixing Secrets

Downloaded Over 19,455 times!

Discover how to make your kick and bass hit hard by cutting (NOT boosting) the right frequencies! Plus, more counterintuitive ways to get fuller yet controlled low-end in your mix. Download this 40-minute workshop by Matthew Weiss, now for FREE!

Powered by ConvertKit